# # inittab This file describes how the INIT process should set up # the system in a certain run-level. # # Version: @(#)inittab 2.04 17/05/93 MvS # 2.10 02/10/95 PV # 3.00 02/06/1999 PV # 4.00 04/10/2002 PV # # Author: Miquel van Smoorenburg, # Modified by: Patrick J. Volkerding, # # # 02-Sep-05 amo Added "4" to c[1-5], 6 already had "4", re-enable init 4 at bottom # 03-Sep-05 amo Added "5" for KDE # # # These are the default runlevels in Slackware: # 0 = halt # 1 = single user mode # 2 = unused (but configured the same as runlevel 3) # 3 = multiuser mode (default Slackware runlevel) # 4 = X11 with KDM/GDM/XDM (session managers) # 5 = unused (but configured the same as runlevel 3) # 6 = reboot # Default runlevel. (Do not set to 0 or 6) id:3:initdefault: # System initialization (runs when system boots). si:S:sysinit:/etc/rc.d/rc.S # Script to run when going single user (runlevel 1). su:1S:wait:/etc/rc.d/rc.K # Script to run when going multi user. rc:2345:wait:/etc/rc.d/rc.M # What to do at the "Three Finger Salute". ca::ctrlaltdel:/sbin/shutdown -t5 -r now # Runlevel 0 halts the system. l0:0:wait:/etc/rc.d/rc.0 # Runlevel 6 reboots the system. l6:6:wait:/etc/rc.d/rc.6 # What to do when power fails. pf::powerfail:/sbin/genpowerfail start # If power is back, cancel the running shutdown. pg::powerokwait:/sbin/genpowerfail stop # These are the standard console login getties in multiuser mode: c1:12345:respawn:/sbin/agetty 38400 tty1 linux c2:12345:respawn:/sbin/agetty 38400 tty2 linux c3:12345:respawn:/sbin/agetty 38400 tty3 linux c4:12345:respawn:/sbin/agetty 38400 tty4 linux c5:12345:respawn:/sbin/agetty 38400 tty5 linux c6:12345:respawn:/sbin/agetty 38400 tty6 linux # # 14-Sep-04 amo RS232 console on Com0 # -h hardware flow # -L local # S0:3:respawn:/sbin/agetty -h -L 38400 ttyS0 vt100 #1:3:respawn:/sbin/agetty -h -L 9600 ttyS1 vt100 # # # Start X11 in "init 4", KDE in "init 5" ( kde installed from rc.local ) # --------------------- x1:45:wait:/etc/rc.d/rc.4 # # # End of /etc/inittab